Hey at least it's only one...

Just one, broke in the aluminum though >:(

Drilling

Drilling 5 million holes again... Maybe I'll set a new record breaking 10 bits this time.!?

Recycle your filings too

Well I just pulled it off

Literally I just pulled it off like 4 sec ago and well here's the results...

Problem... Serious

Well during the turn on stage something happened... First relay tripped in sending pwr thought the ballast resistors to the transformer, second clicked in shorting the resistors... Full pwr away... Then 5 seconds later, the unmute lifted and ...well pow... Correction POW. The following are just investigation shots... Nothing changed, nothing moved.. Other than the heat sink for my drivers to reaveal the board..

More testing

No.. Just listening to music here... With a very powerful amp :)

Well right when I was turning it on the worse happened...

Front plate...

Here is the front plate for the beast... Freshly cut...

And I need to get some bigger meters...

Now for some polishing, and lots of sanding. :(

New plate...

Due to eddies current I can't seem to use a metal plate on top of my transformer and ground it to my frame. There was almost 1.2 volts of high current electricity standing between it... With 3 14-2 guage wires they ran almost red hot and smoked up... Do here is my (hopefully) AWSOME solution...

Back to scratch...

Well after an hour, or just watching mythbusters, it's finished.

Time for the new plate...

Long awaited update....

Ok it's time, time to take off my test bench and makin' room for the new plate. Say buh-bye.

A problem

Due to (I think) eddys current, I am getting some hot grounding wires. I am currently working on the situation but I don't know what to do now. I guess I can start by riveting the Tranny down.

The final order in is in action...

Hand grips, more outputs, and binding post.

Noise cover

Hey just to give you guys a long overdue update, but I make a noise cover for the transformer, on it I mounted the aux tranny, soft start resistors and pwr/relay board, pics to come soon