Another heat sink revision...

Well the original heatsink was too high, so I had to remake one, now I will slap it on and connect the mainboard.

Pwr supply test

Check... Board installation now

Project update

I know it's been a while because I don't want to plug it in.... After I plug it in then I can throw the main board in and the other outputs but I have been dreading it... I still can't get the nerve to plug it in :(

Goal

My goal is to be FINISHED with the amp before April Ends, Totally finished. As for progress, i drilled the holes in the cross member and put the back pwr switch in :) I changed out the mainboard trannies, a few resistors and currently workin on the heatsink and mica for it as Mouser didnt send any mica with the actual trannies.

Sorry for no pics...

Well guys, I got the left rails done(after maby 6 or so screws broke on me "screw them" (no pun intended)) and I also got a 24 pin mother board plug and used it for my main board 😃 all the pins are doubled, even though I think even that is overkill but I used up a row and I was like I might as well double them so I did. The switch will get drilled for the pwr soon (Ie tomorrow) and then the back plate should be able to go on.... I still need a half inch drill bit (probally more like 3/4) to drill a hole through a cross member to bolt up my back handles.... Ugh that's about it... Need to layout transistors... Check for shorts... Replace components...( gulp) cross fingers.... ( even bigger gulp) and plug the beast in and turn her on............ No worries right, knock on wood for safe keepin

Work hault/stop?

There might not be alot of work done on the amp today, yesterday evening, although there was no post, I got the pos and neg rail from recs to caps done, drain resistors also check.

A friend PS3 broke... Cd problems I think I fixed it....